///
E10 Standby Generator Integration: Setup and Features Guide
E10 Standby Generator Integration: Setup and Features Guide
The Anker SOLIX E10 + Power Dock now supports 240V Standby Generators. Enjoy automatic start/stop, quiet time mode, and remote control for a truly whole-home backup solution.
For homeowners who already rely on a heavy-duty standby generator, the wait is over. The latest May 2026 firmware update for the Anker SOLIX E10 + Power Dock now fully supports 240V Standby Generators.
This integration bridges the gap between traditional backup power and modern smart home energy. You can now combine the unlimited runtime of your standby generator with the instant, silent response of the E10 battery system, all managed automatically through one app.
Smarter Automation for Your Home
With this update, your standby generator becomes an intelligent extension of your E10 system.
-
Automatic Start & Stop
Stop worrying about battery levels during long outages. The system automatically triggers your generator when the E10 battery drops to your set threshold and shuts it down once fully charged.
-
Quiet Time Mode
Nighttime noise is a thing of the past. Configure lower start/stop thresholds during your sleeping hours. The generator will only run when power is critically low, ensuring a peaceful night.
-
Remote Control & Monitoring
Check your generator's status or manually start/stop it from anywhere using the Anker SOLIX App. You are always in control.
-
Auto Exercise Cycle
Standby generators need regular maintenance to stay reliable. The E10 system now schedules automatic exercise cycles to keep your engine in top condition, preventing fuel degradation and battery issues.
Important Prerequisites
Before you begin, please ensure your setup meets the following requirements to guarantee safe and efficient operation:
-
Hardware Requirement: This feature is exclusively available for the E10 + Power Dock setup.
-
Generator Compatibility: Your standby generator must support Two Wire or Utility Sensing control modes.
-
Power Capacity: The system supports standby generators with a maximum surge power of 24kW.
-
Professional Installation: All wiring modifications must be performed by a licensed electrician. Improper installation may void your generator's warranty.
Note: When the system is running on standby generator power, the E10 prioritizes charging or bypassing. It does not output power to the home simultaneously during this mode.
Ready to Upgrade Your System?
For detailed wiring diagrams and setup instructions, please visit our Support Center.
Ensure your Anker SOLIX App is updated to the latest version to install the new firmware and unlock these features. Read the Update Guide →
Featured Articles
Be the First to Know
